|P0101 2011 NISSAN SENTRA code possible causes

Dirty Mass Air Flow (MAF) sensorDirty air filterFaulty Mass Air Flow (MAF) sensorMAF sensor harness is open or shortedMAF sensor circuit poor electrical connectionIntake air leaks

|How do I fix the P0101 2011 NISSAN SENTRA code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector"s pins.

You are watching: 2011 nissan sentra mass air flow sensor


|P0101 2011 NISSAN SENTRA code tech notes

Before replacing the Mass Air Flow (MAF) sensor, try replacing the air filter and cleaning the MAF sensor with low compress air or MAF sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replace the MAF sensor.There is a factory service bulletin for the 2011-2012 Nissan Sentra:If the P0101 code is set and there are no drivability problems, the factory service bulletin suggests reprogramming the Engine Control Module (ECM) to repair the problem. Bulletin No. NTB12-051d.

|Cost of diagnosing the P0101 2011 NISSAN SENTRA code

Labor: 1.0

The cost of diagnosing the P0101 2011 NISSAN SENTRA code is 1.0 hour of labor. The auto repair"s diagnosis time and labor rates vary by location, vehicle"s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0101 2011 NISSAN SENTRA code detected?

- A high voltage from the sensor is sent to Engine Control Module (ECM) under light load driving condition. - A low voltage from the sensor is sent to ECM

|What are P0101 2011 NISSAN SENTRA code possible symptoms?

Engine Light ON (or Service Engine Soon Warning Light)Engine stallEngine running roughExcessive fuel consumptionExcessive smoke

|P0101 2011 NISSAN SENTRA code description

The Mass Air Flow (MAF
) sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM).

See more: What Is The First Step In The Boot Process From The System Bios?

The temperature of the hot film is controlled by the ECM a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.
*

|Need more information with the P0101 2011 NISSAN SENTRA code?

Need more information on how to fix the P0101 2011 NISSAN SENTRA code?Get Access to Factory Service Manuals

|Need help with a P0101 2011 NISSAN SENTRA code?

Get the P0101 2011 Nissan Sentra code diagnosed by a professional: Find a repair shop in your area

|P0101 2011 NISSAN SENTRA code comments

Help us improve couchsurfingcook.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0101 2011 Nissan Sentra code? Have you replaced any parts? Any information is appreciated. Thanks